Journal of the Japan Institute of Energy
New Arrival Alert : OFF

You can use this feature after you logged into the site.
Please click the button below.

Log in / Sign up
ONLINE ISSN: 1882-6121
PRINT ISSN: 0916-8753

Journal of the Japan Institute of Energy Vol. 76 (1997), No. 5

  • Coal Research in Poland

    pp. 398-404

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.3775/jie.76.398

    Coal has an exceptional position in the Polish economy both as a major indigenous source of energy and an important raw material for chemical and carbon industries. This review outlines the current situation and prospects in production and utilization of solid fossil fuels in Poland. Principal research centers dealing with science and technology of coal and related materials are presented. Some recent research activities in the field are summarized, particularly concerning fundamental studies on the structure and properties of coal, metallurgical coke manufacture, clean coal technologies, coal liquefaction, and the use of coal and its derivatives as precursors of carbon materials.
    x

    Readers Who Read This Article Also Read

    1. History of Miike mine Journal of the Japan Institute of Energy Vol.76(1997), No.6
  • Effects of Mild Treatment on the Properties of the Char Product by the Flash Pyrolysis of Wandoan coal

    pp. 405-411

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.3775/jie.76.405

    The effects of mild acid and/or tetralin treatments on the flash pyrolysis reactivity of Wandoan coal were investigated in order to improve the product distribution as well as to modify the properties of the char. The reactivity of Wandoan coal at 590°C for 5sec by Curie-point pyrolyzer was improved by hydrogen chloride or acetic acid aq./20 vol% alcohol pretreatment, the char yield being decreased with increased yields of gas and tar. Impregnation of tetralin also reduced the char yield to 63.5%. A combination of acid and tetralin pretreatments slightly reduced further the char yield.
    The porosity (area) of the pyrolyzed char was influenced very much by the acid treatment. The macropores of which areas ranging from 205 to 411μm2 were increased significantly by the acetic acid pretreatment. These results revealed that such acid pretreatments may enhance the gasification and the volatilization of tar fraction and improved the fusibility of coal to enlarge the porosity.
  • Ignition of Methane-Air Mixtures by Isothermal Hot Wires

    pp. 412-420

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.3775/jie.76.412

    Hot surface ignition of methane-air mixtures has been experimentally studied in normal gravity and microgravity. The primary aim of this research is to explain the effects of natural convection and catalytic reaction on the hot surface ignition in a closed vessel. The hot surfaces used are platinum wire for catalyst and nickel wire for non-catalyst. In order to define the initial condition and make the analysis simple, the following control unit was developed; which heats the wire to the setting temperature in a very short time, and maintains the wire temperature constant until ignition. From experimental results, ignition temperatures with platinum wire are higher than those with nickel wire by the catalytic inhibition of ignition due to the reactant depletion on the surface of the wire. Ignition temperatures with platinum wire are highest near the stoichiometric mixture ratio and decrease with equivalence ratio depart from stoichiometric mixture ratio, while those with nickel wire increase with equivalence ratio. Ignition temperatures in normal gravity are higher than those in microgravity. Natural convection supplies reactants to the platinum wire surface, and therefore reactants are consumed because of promoting catalytic reaction in normal gravity.

Article Access Ranking

22 Feb. (Last 30 Days)

  1. Thermodynamic Modeling of the SFCA Phase Ca2(Fe, Ca)6(Fe, Al, Si)6O20 Tetsu-to-Hagané Advance Publication
  2. Effect of Nut Coke Addition on Physicochemical Behaviour of Pellet Bed in Ironmaking Blast Furnace ISIJ International Advance Publication
  3. Thermal Driving Demonstration of Li4SiO4/CO2/Zeolite Thermochemical Energy Storage System for Efficient High-Temperature Heat Utilizations ISIJ International Advance Publication
  4. Evolution of Blast Furnace Process toward Reductant Flexibility and Carbon Dioxide Mitigation in Steel Works ISIJ International Vol.56(2016), No.10
  5. Effects of Sulfur and Titanium Interaction in Molten Pig Iron on Erosion of Carbon Brick ISIJ International Vol.59(2019), No.1
  6. Chemical Structure of Si–O in Silica Fume from Ferrosilicon Production and Its Reactivity in Alkali Dissolution ISIJ International Advance Publication
  7. Viscosity Property and Melt Structure of CaO–MgO–SiO2–Al2O3–FeO Slag System ISIJ International Vol.59(2019), No.1
  8. Preparation of High-Carbon Metallic Briquette for Blast Furnace Application ISIJ International Vol.59(2019), No.1
  9. Preface to the Special Issue “Heterogeneous Structure Control: Towards Innovative Development of Metallic Structural Materials” Tetsu-to-Hagané Vol.105(2019), No.2
  10. Effects of Impurities and Processing Conditions in Al–1%Mn Alloys on the Formation of Thermally Stabilized Substructures MATERIALS TRANSACTIONS Vol.59(2018), No.11

Search Phrase Ranking

22 Feb. (Last 30 Days)

  1. blast furnace
  2. blast furnace productivity
  3. blast furnace permeability
  4. 鉄と鋼
  5. clean steel
  6. hydrogen brittle
  7. mold flux
  8. takayuki maeda
  9. mill setup
  10. mill-setup