Journal of the Japan Institute of Energy
New Arrival Alert : OFF

You can use this feature after you logged into the site.
Please click the button below.

Log in / Sign up
ONLINE ISSN: 1882-6121
PRINT ISSN: 0916-8753

Journal of the Japan Institute of Energy Vol. 76 (1997), No. 12

  • Function of Hydrogenated Solvent in the Coal Liquefaction System (II)

    pp. 1156-1163

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.3775/jie.76.1156

    The influence of heavy distillate and middle distillate in the coal liquefaction solvent was investigated with a 5 L batch-autoclave.
    The following conclusions are obtained.
    (1) Under the coal liquefaction condition, heavy distillate in the solvent is effective for the coal conversion, but not for the fragment capping, as compared with middle distillate in the solvent. Consequently, the heavy distillate relatively reduces the oil yield.
    (2) The severe hydrotreatment for both the heavy distillate and the middle distillate enhances coal liquefaction reaction.
    (3) An increase of the content of donatable hydrogen in the heavy distillate produces high oil yield because of an improvement of the fragment capping, and that in the middle distillate promotes subsequent reaction. Consequently, severe hydrotreatment for the heavy distillate is effective than that for the middle distillate.
    (4) The heavy distillate is different from the middle distillate on the effect for coal liquefaction and of severe hydrotreatment. It is necessary for the suitable distillate design of the recycle solvent in coal liquefaction system.
  • Effect of Volatile and Ash Contents on Flame Propagation Properties for Pulverized Coal Dust Clouds Ignited by Pulsed Laser

    pp. 1164-1169

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.3775/jie.76.1164

    Effect of volatile and ash contents on cloud ignition behaviors were examined for pulverized coal dust clouds, that were suspended in a laminar upward flow and heated by a single-pulsed YAG laser. We compared burning times of volatile matter, flame propagation velocities and lean flammability limits for several coals. The coals contains almost same volatile matter, but different ash. The present results showed that the burning time of volatile matter, flame propagation velocity and lean flammability limit were mainly determined by volatile content. The effects of ash content were small. The maximum flame propagation velocity increased with volatile content. The velocity increased the third as much as when volatile content increased from 10% to 20%.

Article Access Ranking

01 Dec. (Last 30 Days)

  1. Heat conduction through different slag layers in mold. Thermal conductivity measurement of commercial mold fluxes ISIJ International Advance Publication
  2. Deformation of Non-metallic Inclusions in Steel during Rolling Process: A Review ISIJ International Vol.62(2022), No.11
  3. Activity of Chromium Oxide in Calcium Silicate Bearing Molten Slag for Highly Clean Chromium Steel Refining Process ISIJ International Advance Publication
  4. Effects of basicity and Al2O3 content on the crystal structure of silico-ferrite of calcium and aluminum ISIJ International Advance Publication
  5. Behavior and kinetic mechanism analysis of dissolution of iron ore particles in HIsmelt process based on high-temperature confocal microscopy ISIJ International Advance Publication
  6. Corrections of the figure in the paper “Effect of Cerium and Magnesium Addition on Evolution and Particle Size of Inclusions in Al-killed Molten Steel” [ISIJ International, Vol. 62 (2022), No. 9, pp. 1852-1861] ISIJ International Vol.62(2022), No.11
  7. Dissolution of Chromium from Steelmaking Slag–Cr-containing Mineral Phases and Synthetic Slags– Tetsu-to-Hagané Vol.108(2022), No.11
  8. Effect of Molten Steel Composition on Inclusion Modification by Calcium Treatment in Al-Killed Tinplate Steel ISIJ International Advance Publication
  9. Characterization and Control of Secondary Phase Precipitation of Nb–V–Ti Microalloyed Steel during Continuous Casting Process ISIJ International Vol.62(2022), No.11
  10. Improvement of Sinter Productivity and Qualities by Placing Low Slag Green Pellet at Lower Layer of Sinter Packed Bed ISIJ International Vol.62(2022), No.11

Search Phrase Ranking

01 Dec. (Last 30 Days)

  1. blast furnace
  2. si-killed spring steel
  3. converter slag
  4. 高温変形抵抗
  5. 钢渣脱磷
  6. 5%nickel
  7. coatings hot formed steel
  8. free lime
  9. secondary cooling billet
  10. si killed spring steel wire rod