論文検索サイト

鉄と鋼 Vol. 53 (1967), No. 8

ISIJ International
belloff

Grid List Abstracts

オンライン版ISSN: 1883-2954
冊子版ISSN: 0021-1575
発行機関: The Iron and Steel Institute of Japan

Backnumber

  1. Vol. 110 (2024)

  2. Vol. 109 (2023)

  3. Vol. 108 (2022)

  4. Vol. 107 (2021)

  5. Vol. 106 (2020)

  6. Vol. 105 (2019)

  7. Vol. 104 (2018)

  8. Vol. 103 (2017)

  9. Vol. 102 (2016)

  10. Vol. 101 (2015)

  11. Vol. 100 (2014)

  12. Vol. 99 (2013)

  13. Vol. 98 (2012)

  14. Vol. 97 (2011)

  15. Vol. 96 (2010)

  16. Vol. 95 (2009)

  17. Vol. 94 (2008)

  18. Vol. 93 (2007)

  19. Vol. 92 (2006)

  20. Vol. 91 (2005)

  21. Vol. 90 (2004)

  22. Vol. 89 (2003)

  23. Vol. 88 (2002)

  24. Vol. 87 (2001)

  25. Vol. 86 (2000)

  26. Vol. 85 (1999)

  27. Vol. 84 (1998)

  28. Vol. 83 (1997)

  29. Vol. 82 (1996)

  30. Vol. 81 (1995)

  31. Vol. 80 (1994)

  32. Vol. 79 (1993)

  33. Vol. 78 (1992)

  34. Vol. 77 (1991)

  35. Vol. 76 (1990)

  36. Vol. 75 (1989)

  37. Vol. 74 (1988)

  38. Vol. 73 (1987)

  39. Vol. 72 (1986)

  40. Vol. 71 (1985)

  41. Vol. 70 (1984)

  42. Vol. 69 (1983)

  43. Vol. 68 (1982)

  44. Vol. 67 (1981)

  45. Vol. 66 (1980)

  46. Vol. 65 (1979)

  47. Vol. 64 (1978)

  48. Vol. 63 (1977)

  49. Vol. 62 (1976)

  50. Vol. 61 (1975)

  51. Vol. 60 (1974)

  52. Vol. 59 (1973)

  53. Vol. 58 (1972)

  54. Vol. 57 (1971)

  55. Vol. 56 (1970)

  56. Vol. 55 (1969)

  57. Vol. 54 (1968)

  58. Vol. 53 (1967)

  59. Vol. 52 (1966)

  60. Vol. 51 (1965)

  61. Vol. 50 (1964)

  62. Vol. 49 (1963)

  63. Vol. 48 (1962)

  64. Vol. 47 (1961)

  65. Vol. 46 (1960)

  66. Vol. 45 (1959)

  67. Vol. 44 (1958)

  68. Vol. 43 (1957)

  69. Vol. 42 (1956)

  70. Vol. 41 (1955)

鉄と鋼 Vol. 53 (1967), No. 8

Consideration on Decarburization Reaction in an Oxygen Converter and Possibility of the Computing Control on its Basis

Takehiko FUJII, Taiji ARAKI, Katsukiyo MARUKAWA

pp. 973-982

抄録

Considerations and analyses were done on the mechanism of decarburization reaction in the oxygen steelmaking process by the data obtained from the laboratory work, the open hearth furnace, and the oxygen converter.
Authors found that the blowing time of an oxygen converter could be specified into the three periods according to the characteristics of decarburization reaction which takes place in the vessel. Authors connected it with a control system for the converter practice, and named it “Decarburization Model System.”
As the result of many trials, authors pointed out a possibility of computing control of bath carbon and temperature in this direction.

ブックマーク

SNSによる共有

論文タイトル

Dissolution of Steel Cylinder into Liquid Fe-C Alloy

Mineo KOSAKA, Susumu MINOWA

pp. 983-997

抄録

Dissolution of solid steel cylinder into molten Fe-C alloy was investigated at the temperature from 1300°C to 1500°C.
In this paper, the viscosity and the density of the melt and the diffusion coefficient of carbon were estimated from the literatures at the solid-liquid interface i. e. at the liquidus concentration of carbon, CL.
Nondimensional correlation for the mass-transfer was analysed using above estimated physical properties and diffusion coeff.
Correlation for the rotated or static cylinder was obtained as follows:
JD= (k/U)(Sc) 2/3=0⋅064 (Re) -0.25
102<Re<104: rotated cylinder
Sh=0⋅11 (Gr.m×Sc) 1/3
109<Gr·m × Sc<1011: static cylinder
Utilizing the nondimensional correlation of a model test by benzoic acid-water system, the unknown ratesof stirring of molten Fe-C alloy melted by some laboratorial H. F. furnace could be roughly estimated from the rates of dissolution of steel cylinder.

ブックマーク

SNSによる共有

論文タイトル

On the Variations of the Components in the Inclusion

Yasushi KOJIMA, Kokichi SANO

pp. 997-1006

抄録

After the equilibrium between molten iron and the systems FeO-MnO-SiO2 and FeO-MnO-CrO-SiO2 was established in the silica crucible at 1650°C, the temperature was lowered rapidly to 1550°C and this temperature maintained till the equilibrium was attained again. The variations of the concentration of the components in the liquid iron and slag were measured. The results obtained are summarized as follows:
1) MnO and FeO were reduced in the system FeO-MnO-SiO2 slag by the excess silicon due to the lowering temperature at more than 0⋅18%, manganese in the liquid iron. The relation between reduction ratio of MnO and the concentration of silica was estimated. Up to 0⋅18% manganese, this excess silicon, however, was not sufficient to deoxidize, MnO was not reduced in this case.
2) FeO, MnO and CrO were reduced in the system FeO-MnO-CrO-SiO2 slag by the excess silicon same as the system FeO-MnO-SiO2 in the case of 5%Cr. But in cases of 9% and 14% Cr, the reduction of these oxides did not occur. It was considered that the new phase was formed at the boundary of both phases.
3) It was anticipated from the experimental results obtained above that the equilibrium between inclusion and molten iron was established fast. The mechanism of the formation of oxide inclusions composed of FeO-MnO-SiO2 system were examined experimentally by addition of deoxidizers. The results showed that if the processes of formation of oxide inclusions composed of FeO-MnO-SiO2 system were examined experimentally by addition of deoxidizers. The results showed that if the processes of formation of inclusions could be known, based on the equilibrium data, the components of inclusion could be evaluated from the concentration of dissolved elements in the liquid iron.

ブックマーク

SNSによる共有

論文タイトル

Effect of Impurities on the Secondary Recrystallization in Silicon Iron

Takashi MATSUOKA

pp. 1007-1023

抄録

An investigation has been made on the effects of impurities on the development of (110)[001] secondary recrystallization texture in silicon iron. While dispersed inclusions, TiC, VN, NbC, and A1N, were observed to have the ability to promote secondary recrystallization, BN and ZrC, have not. Necessary amounts of impurity elements were found to be 0.04% Ti, 0.07% V, and 0.02% Nb, respectively. The solubility products [%M][%C] or [%M][%N](M: impurity element) of effective inclusions were estimated to be from 10-3 to 10-5 at the secondary recrystallization temperature. Inclusions of the order of 0.1 micron in size were observed to be dispersed more densely than 1012 particles/cm3 in final gauge strips in which secondary recrystallization occurred appreciably.

ブックマーク

SNSによる共有

論文タイトル

Crystal Structures of Nonmetallic Inclusion in Iron and Steel, and its Homologue

Kiichi NARITA

pp. 1024-1055

ブックマーク

SNSによる共有

論文タイトル

この機能はログイン後に利用できます。
下のボタンをクリックしてください。

詳細検索

論文タイトル

著者

抄録

ジャーナル名

出版日を西暦で入力してください(4桁の数字)。

検索したいキーワードを入力して下さい