材料と環境 Vol. 68 (2019), No. 10
Backnumber
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Nov. (Last 30 Days)
材料と環境 Vol. 68 (2019), No. 10
コンクリート中鉄筋の腐食評価方法
大谷 俊介, 篠田 吉央, 堀越 直樹, Suad Al-Bahar
pp. 262-269
DOI:
10.3323/jcorr.68.262抄録
The need for the corrosion diagnosis of reinforcing bars is likely to increasing owing to the increasing use of seawater-mixed concrete and the aging of existing structures. In this paper, new methods were introduced to diagnose the corrosion of reinforcing bars. In addition, an outline of the salt damage deterioration diagnosis method was provided to the engineers at Kuwait Institute for Scientific Research (KISR). Further, a comparison was conducted between values obtained through on-site corrosion diagnosis of concrete structures and two types of laboratory-based electrochemical measurements.
モルタルのインピーダンススペクトルに観察される容量性半円と細孔構造の関係
染谷 望, 星 芳直
pp. 270-273
DOI:
10.3323/jcorr.68.270抄録
An electrochemical impedance measurement of mortar specimen was performed to investigate the relationship between the impedance spectrum and the pore structure in mortar. The mortar specimens with different pore size were prepared for the impedance measurement. The capacitive loop or part of loop, which are related to the physical properties of mortar, were observed in the impedance spectra of mortar specimens. The mortar resistance between the pores and the capacitance between pores filled with solution in mortar specimen(RMpore and CMpore)were estimated by curve-fitting of impedance spectrum using an equivalent circuit. The values of RMpore and CMpore were increased and decreased, respectively, when the size of pores became smaller in mortar specimens. These results imply the decreasing the water pathway of pores in mortar due to the increasing small pores in mortar.
コンクリートの練混ぜ水としての海水の適用性について
濵田 秀則, ダリア パタ, サブリナ ハラハップ
pp. 274-279
DOI:
10.3323/jcorr.68.274抄録
In this 21st century, sustainability is an issue of extreme importance for humankind. As regards drinking water, a serious shortage is expected by 2050, when one-third of the world's population is predicted to lack sufficient access to drinking water. In the field of concrete, billions of tons of freshwater is consumed annually for mixing, curing and washing concrete. Seawater is presently not permitted to be used for these purposes. Active use of seawater in the field would contribute to more effective use of freshwater resources.Based on this social situation, JCI (Japan Concrete Institute) set the committee to research the possibility of seawater usage in concrete production, such as concrete mixing, concrete curing etc. Based on the results, issues surrounding the use of seawater and possible solutions are proposed. In this report, readers are expected to find the committee activities and committee attitude. In Kyushu University, recent several years, a research on concrete characteristics mixed with seawater is continued. In this paper, a discussion on seawater utilization as concrete mixing water based on the research results is also summarized.Actually, this paper is a summary paper of three presentations by authors, Hamada, Patah, Harahap, in the JSCE conference held in Toyama, 2018 October.
ひび割れを有するコンクリート中の鉄筋の腐食挙動調査
竹内 陽祐, 石井 龍太, 上庄 拓哉, 津田 昌幸, 渡辺 正満, 宮田 恵守
pp. 280-283
DOI:
10.3323/jcorr.68.280抄録
To examine rebar corrosion in cracked concrete, we have exposed cracked test pieces of pre-stressed concrete containing two rebars to the outdoors and observed the electrochemical behavior. After one year from the start of the exposure test, the potential difference between rebars increased, so it seemed one of rebars has corroded. However, as the exposure test proceeded, the potential difference decreased to the initial state. In addition, destructive observations of test piece revealed that only one rebar had corroded. These results indicate that just one rebar was repassivated after the depassivation in cracked concrete.
海水練りコンクリート中における鉄筋の腐食
山路 徹, 宮坂 松甫, Adel Husain
pp. 284-287
DOI:
10.3323/jcorr.68.284抄録
The authors participated in a project “Technical collaboration project on seawater utilization for concrete structure of petroleum facilities as construction and maintenance management, Kuwait” that Japan Society of Corrosion Engineering (JSCE) received from Japan Cooperation Center Petroleum (JCCP), and supported research in Kuwait.This paper is based on the knowledge of JCI Technical Committee Report on the Use of Seawater in Concrete and others about corrosion of rebar in concrete using seawater as mixing water.
クウェート国におけるコンクリートの硫酸塩劣化と海水練りコンクリートの耐硫酸塩性
吉田 夏樹, Abdulsalam Safaa, Joseph Antony
pp. 288-294
DOI:
10.3323/jcorr.68.288抄録
In Kuwait, where freshwater resources are scarce, the use of seawater-mixed concrete has been considered. In the Middle East countries where sulfate soils are widespread, it is necessary to confirm sulfate resistance of concrete. In a concrete member constructed in sulfate-bearing soil, different deterioration phenomena are expected to occur in the ground water level, from the ground water level to the ground surface, and above the ground surface. As a result of Na2SO4 immersion test using 10 mix proportions of mortar specimens, an admixture designed to precipitate larger amount of ettringite was found ineffective for sulfate resistance in seawater-mixed concrete. Based on the results of these experiments, it is necessary to prepare specimens using materials in Kuwait and to carry out exposure tests in the actual soil environment in Kuwait.
論文アクセスランキング
21 Nov. (Last 30 Days)
-
-
-
-
Development of a Low-carbon Sintering Process Technology and Its Application to a Pilot-scale Sintering Testing
ISIJ International Vol.64(2024), No.13
-
凝固過程における溶鋼中からAl2O3上へのMnSの晶出挙動
鉄と鋼 早期公開
-
Molecular dynamics simulation of viscosity of the CaO, MgO and Al2O3 melts
ISIJ International 早期公開
-
-
凝固過程のミクロ偏析による溶質濃度分布の定量的理解
鉄と鋼 早期公開
-
-
Reduction and Carburization Behaviors of Iron Oxide Composite with Iron Carbide and Free Carbon
ISIJ International 早期公開
この機能はログイン後に利用できます。
下のボタンをクリックしてください。