材料と環境 Vol. 58 (2009), No. 9
Backnumber
-
Vol. 74 (2025)
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Feb. (Last 30 Days)
材料と環境 Vol. 58 (2009), No. 9
銅の大気腐食における塩基性硫酸銅及び塩化物の生成
渡辺 正満, 松本 守彦, 桑木 伸夫, 酒井 潤一
pp. 328-334
DOI:
10.3323/jcorr.58.328抄録
Basic copper sulfates and copper chlorides are known to form in addition to cuprite during outdoor atmospheric corrosion of copper. Among the basic copper sulfates, posnjakite is reported to form in the early stage and then transform into brochantite when during the course of exposure. In contrast, copper chlorides, such as atacamite and nantokite, are reported not to form in the early stage. Using thermodynamic data at 298 K, we have calculated the conditions under which basic copper sulfates and chlorides are deposited on the surface of exposed copper. For posnjakite, the minimum sulfate ion concentration needed for deposition was calculated to be 6.3×10−4 M given a cupric ion concentration of 1×10−6 M and a pH of 7. The posnjakite formation found on copper exposed in summer in urban areas is reasonably explained by the observation that the sulfate ion concentration in the surface electrolyte exceeded the minimum concentration. Although the sulfate ion concentration in the surface electrolyte exceeded the minimum concentration during winter, there was no evident posnjakite formation. This is explained by the low relative humidity and the short ‘time of wetness’. For atacamite, the minimum chloride ion concentration needed for deposition was calculated to be 2.5×10−2 M given a cupric ion concentration of 1×10−6 M and a pH of 7. Although the chloride ion concentration in the surface electrolyte on copper exposed in urban areas exceeded the minimum concentration needed to deposit atacamite, peaks originating from this phase were not observed. A possible explanation for this is the slow formation rate of atacamite. Posnjakite depostition was found to be predominant, particularly in winter. This is reasonable give that posnjakite is more stable than atacamite. This also explains why there was a lack of atacamite formation in the early stage of the exposure.
他の人はこちらも検索
材料と環境 Vol.60(2011), No.9
水溶性天然ガスプラントにおける炭素鋼の微生物腐食
半田 拓弥, 大野 さやか, 茂手木 桃子, 宮永 一彦, 丹治 保典
pp. 335-340
DOI:
10.3323/jcorr.58.335抄録
In the aqueous natural gas plants, the injection well was corroded after a few years because of sulfuric acid addition to adjust pH for iodine separation. To identify the corrosion factor, microbial communities and corrosion in the plants were compared using sulfuric acid or hydrochloric acid as a pH conditioner. Genus Pseudomonas and methanogenic archaea were dominant in 16S rRNA gene library constructed from production water. The dominant SRB species were different depending on the pH conditioner. According to DAPI staining and DGGE analysis, the cell concentration increased and bacterial community changed. It was assumed that this phenomenon occurred due to contamination by microorganisms from the surrounding environment. The three month corrosion study showed that the general corrosion rate of carbon steel coupons in the injection tank using sulfuric acid as a pH conditioner was four times higher and the biofilm weight was one and a half times bigger than the injection tank using hydrochloric acid. One possible reason is that hydrogen sulfide produced by SRB corroded carbon steel. However, the pitting corrosion rate was the highest in the receiving tank which used no acid. This result indicated that metal surface corrosion is caused a mechanism which includes an oxygen concentration cell formed by the heterogeneously-attached biofilm.
論文アクセスランキング
21 Feb. (Last 30 Days)
-
Wettability of CaS Against Molten Iron at 1873 K
ISIJ International Vol.65(2025), No.2
-
Surface defect detection of continuous casting slabs based on deep learning
ISIJ International 早期公開
-
Structure of Metallic Iron Formed in Iron Ores by CO-H2 Reduction
ISIJ International 早期公開
-
Perspectives on the Promising Pathways to Zero Carbon Emissions in the Steel Industry toward 2050
ISIJ International Vol.65(2025), No.2
-
Characterization of the three-dimensional pore structure of coke using the maximal ball method
ISIJ International 早期公開
-
Molecular Dynamics Analysis of the Mg2+ Structure Behavior in SiO2-CaO-Al2O3-MgO Slag System
ISIJ International 早期公開
-
Coating Structure and Corrosion Mechanism of Zn-19%Al-6%Mg Alloy Coating Layer
ISIJ International Vol.65(2025), No.2
-
-
Preface to the Special Issue on "Effects of Cu and Other Tramp Elements on Steel Properties"
ISIJ International Vol.37(1997), No.3
-
この機能はログイン後に利用できます。
下のボタンをクリックしてください。