材料と環境 Vol. 65 (2016), No. 3
Backnumber
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Dec. (Last 30 Days)
材料と環境 Vol. 65 (2016), No. 3
空調機銅製熱交換器を流れる冷却水の水質解析による銅配管の腐食診断
星 芳直, 越智 健太郎, 四反田 功, 板垣 昌幸, 関口 恭一, 平田 陽一, 菱沼 崇
pp. 88-94
DOI:
10.3323/jcorr.65.88抄録
The tendency of pitting corrosion on copper tubes of heat exchangers was investigated by analyzing the quality of cooling water sampled from air-conditioning units at different cities in Japan. A two-dimensional diagram (2DD) was constructed with two parameters chosen from water quality conditions, i.e., total hardness, acid consumption, pH, concentrations of SO42― and Cl―. The results of 2DD analyses demonstrated that the acid consumption was strongly related to the susceptibility of copper pitting corrosion. In order to make a diagnosis of copper pitting corrosion, we proposed a three-dimensional diagram (3DD). The axes of 3DD were the acid consumption, pH and ratio of amount of Cl― + SO42― ions to total anions (HCO3―, Cl― and SO42―). This diagram indicated that the cooling water sampled from air-conditioning units could be divided into high and low pitting corrosion risk categories precisely. In addition, the simulated cooling water was prepared in the laboratory to assist the effectiveness of the proposed 3DD analysis. The anodic polarization curves of copper electrode were measured in the simulated cooling water as the accelerated test for pitting corrosion susceptibility. The 3DD analysis was applied to the discrimination of corrosive properties of simulated cooling water after accelerated test. The surface morphology of copper electrode was analyzed by the optical microscope. The results of 3DD analyses were in good agreement with those of surface morphologies of copper electrode after anodic polarization curve measurement. These results implied that 3DD allowed the screening of cooling water related to the risk of pitting corrosion on copper tubes of heat exchangers.
3種類の自己組織化膜の化学修飾によって作製した超薄二次元重合膜による金属および酸化された金属の腐食防止
荒牧 國次, 志村 正
pp. 95-102
DOI:
10.3323/jcorr.65.95抄録
Three types of self-assembled monolayers (SAMs) were prepared on metals and oxidized metals. They are an alkanethiol SAM chemically adsorbed on Cu and Fe, a benzene derivative SAM adsorbed on Fe by the formation of an Fe-C covalent bond and a carboxylate ion SAM chemisorbed on the surfaces of passivated Fe and hydrated Ce2O3 layer-coated Zn. Ultrathin (nm order thickness), ordered (self-assembly) and interconnected (two-dimensional polymer) protective coatings were synthesized by chemical modification of the SAMs adsorbed on metals and oxidized metals with silane coupling agents. The protective effects of these coatings on corrosion of substrate metals and passive film breakdown in oxygenated neutral solutions are summarized in this paper. The protective efficiency of the polymer coating on Cu in aerated 0.5 M Na2SO4 was extremely high, 99.3% at 1 h of the immersion time but decreased markedly after 20 h. The polymer coating of the benzene derivative SAM protected Fe from corrosion in the long range of the immersion time. Complete protection against corrosion of Fe was accomplished by coverage of a passivated Fe electrode with the two-dimensional polymer coating in the solutions, unless the passive film was broken down.
論文アクセスランキング
21 Dec. (Last 30 Days)
-
Wettability of CaS against molten iron at 1873 K
ISIJ International 早期公開
-
凝固過程における溶鋼中からAl2O3上へのMnSの晶出挙動
鉄と鋼 早期公開
-
-
In-situ Observation of Precipitation and Growth of MnS Inclusions during Solidification of a High Sulfur Steel
ISIJ International Vol.64(2024), No.14
-
-
モデル材料を用いた凝固過程における介在物生成挙動のその場観察
鉄と鋼 早期公開
-
Transition behavior of gas containing suspension from solid-like to liquid-like flows
ISIJ International 早期公開
-
-
Slag-steel reactions in the refining of Advanced High-Strength Steel
ISIJ International 早期公開
-
Chemical and Mechanical Factors on Phosphorus Dissolution Behavior from P-concentrated Slag
ISIJ International Vol.64(2024), No.14
この機能はログイン後に利用できます。
下のボタンをクリックしてください。