材料と環境 Vol. 67 (2018), No. 4
Backnumber
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Dec. (Last 30 Days)
材料と環境 Vol. 67 (2018), No. 4
Ⅲ.腐食の電気化学測定法の応用―ケルビン法―
多田 英司
pp. 145-149
DOI:
10.3323/jcorr.67.145抄録
In this paper, Kelvin method, which can be utilized to measure a contact potential difference between two dissimilar metals, is introduced. A basic principle of Kelvin method for the measurements of the contact potential differences is described. Some measured results in some corrosion systems are also explained.
Ⅲ.腐食の電気化学測定法の応用―ACM型腐食センサ―
元田 慎一
pp. 150-155
DOI:
10.3323/jcorr.67.150抄録
Corrosion behavior under thin water film like atmospheric corrosion is different from underwater environment. Conventional electrochemical techniques can not be applied to such corrosion in a non-submerged environment, and galvanic couples have been applied conventionally. These are commonly referenced as ACM. The authors have tried to evaluate the corrosion of each environment mainly by applying the ACM type corrosion sensors consisting of Fe/Ag couples, exposing them to various environment. In this paper, the electrochemical properties of the ACM sensor were discussed.
Ⅲ.腐食の電気化学測定法の応用―電気化学水晶振動子マイクロバランス法(EQCM法)―
菅原 優
pp. 156-161
DOI:
10.3323/jcorr.67.156抄録
Electrochemical quartz crystal microbalance (EQCM) is a method to determine a mass change related to electrode reactions by measuring a change in the resonance frequency of the quartz. Because the EQCM can detect a nano-scale mass change, it is a powerful tool for analysis of electrode reactions. This article provides an introduction of the EQCM principle, applications of the EQCM to corrosion studies, and problems for measurements.
亜硫酸塩による吸収式冷凍機内の腐食抑制剤溶解度の改善とその鉄の不働態化に及ぼす影響
手塚 花実, 塚澤 尚悟, 八代 仁, 稲部 英則, 平田 陽一, 鳩谷 和希, 菱沼 崇
pp. 164-167
DOI:
10.3323/jcorr.67.164抄録
In absorption refrigeration systems, molybdate is used as a key inhibitor against corrosion of steel, although it is liable to precipitate because of its limited solubility in a concentrated LiBr solution. In this research, the use of sulfite is proposed as a precipitation inhibitor for molybdate and its effect on the passivation of iron is examined. The effect of the stronger passivator of nitrate on the actions of sulfite is also investigated. The results show that sulfite decreases the amount of corrosion of iron and promotes the formation of the oxide layer (MoO2, Fe3O4) on the surface of iron irrespective of presence of nitrate. Thus, sulfite is concluded as an effective additive in an absorption refrigerator for better control of molybdate concentration and corrosion of iron.
リン脱酸銅管の応力腐食割れに及ぼす湿度および酸素濃度の影響
境 昌宏, 熊谷 政人, 大坂 彰, 入江 智芳, 八鍬 浩
pp. 168-171
DOI:
10.3323/jcorr.67.168抄録
C-ring stress corrosion tests under three conditions were carried out to investigate the effect of humidity and oxygen concentration on stress corrosion cracking of phosphorous deoxidized copper tubes. Three conditions were high humidity, low humidity and low oxygen conditions. The relative humidity and oxygen concentration were 100% and about 20% respectively in the high humidity condition. The air in the container with desiccant agent stored at a relative humidity of 90 to 95% in the low humidity condition. In the low oxygen condition, the air in the container was replaced by the nitrogen gas and kept the concentration of oxygen less than 5% during the exposure test. Although stress corrosion cracks occurred in the specimens exposed under both high humidity and low oxygen conditions, the time to occurrence of SCC under the low oxygen condition was longer than that under the high humidity condition. No SCC and intergranular corrosion developed in the specimen exposed under the low humidity condition for one week. It was found that lowering the humidity has an inhibitive effect on the SCC of the phosphorous deoxidized copper tube.
腐食環境下で応力付与した高張力鋼板の腐食速度と拡散性水素の評価
北原 学, 辻 彩, 浅田 崇史, 鈴木 智博, 堀川 敬太郎, 小林 秀敏
pp. 172-178
DOI:
10.3323/jcorr.67.172抄録
Corrosion rate and diffusible hydrogen content of high tensile steel under constant load testing (CLT) in pH2 corrosive solution were investigated using electrochemical impedance spectroscopy (EIS) and thermal desorption spectroscopy (TDS). Rp-1 which is an index of corrosion rate increased as stress increased, which was correlated with the result of corrosion weight loss. This considered to be due to an increase in active nascent surfaces with increasing stress. Diffusible hydrogen content increased with stress, in particular by plastic deformation. The latter was more affected by the effect of corrosion rate and diffusible hydrogen content on stress. In other words, we have concluded that diffusible hydrogen content which related to hydrogen embrittlement was more affected by defects in steels by deformation than hydrogen entry from surface corrosion reaction in corrosion environment.
有機溶媒中におけるアルミニウムの腐食事例
宮坂 松甫
pp. 179-184
DOI:
10.3323/jcorr.67.179抄録
An example of Al corrosion in organic solvent is shown here. Severe Al corrosion occurred in a short time in Polypropylene Glycol Monobutyl Ether (PGME) including about 2% of N-Phenyl-1-Naphtylamine at a temperature of 110℃. An investigation showed that the corrosive medium of Al was PGME itself, the principal component of the solvent. Al is replaced with H of OH group, a component of PGME, to form an organic Al compound, dissolving in PGME, while H separated from PGME changed into hydrogen gas. Here we show the corrosion status, the procedure and results of the investigation, and the results of the corrosion reproduction test.
論文アクセスランキング
21 Dec. (Last 30 Days)
-
Wettability of CaS against molten iron at 1873 K
ISIJ International 早期公開
-
凝固過程における溶鋼中からAl2O3上へのMnSの晶出挙動
鉄と鋼 早期公開
-
-
In-situ Observation of Precipitation and Growth of MnS Inclusions during Solidification of a High Sulfur Steel
ISIJ International Vol.64(2024), No.14
-
-
モデル材料を用いた凝固過程における介在物生成挙動のその場観察
鉄と鋼 早期公開
-
Transition behavior of gas containing suspension from solid-like to liquid-like flows
ISIJ International 早期公開
-
-
Slag-steel reactions in the refining of Advanced High-Strength Steel
ISIJ International 早期公開
-
Chemical and Mechanical Factors on Phosphorus Dissolution Behavior from P-concentrated Slag
ISIJ International Vol.64(2024), No.14
この機能はログイン後に利用できます。
下のボタンをクリックしてください。