材料と環境 Vol. 58 (2009), No. 3
Backnumber
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Dec. (Last 30 Days)
材料と環境 Vol. 58 (2009), No. 3
港湾構造物のライフサイクル管理-IV
善 一章
pp. 82-85
DOI:
10.3323/jcorr.58.82抄録
Based on the PIANC PTC-II WG31 report1), the LCM of port structures has been introduced in Japan2)-6). Especially, the two repair options with equal lives at the Kamsar Port are economically compared using the Present Worth (PW) method. In present worth analysis, the PW is calculated at the Minimum Attractive Rate of Return (MARR), which is an inflation-free interest rate. When inflation occurs, the effect of inflation on the PW method must be examined.
Since a present worth comparison involves calculating the equivalent present value of all future cash flows for each option, the PW of the options must be compared over the same number of years and end at the same time. The PW comparison of options with equal lives is straightforward. When options being compared have different lives, the Annual Worth (AW) method of comparing options is often preferred to the PW method, because AW comparison is performed for only one life cycle.
In this report, the effect of inflation on the PW method is considered using the data of the Kamsar Port in the WG31 report, and the application of the PW and AW methods to unequal-life options is shown.
給湯用銅管の潰食現象に及ぼす気泡挙動の影響
鈴木 忍, 山田 豊, 河野 浩三
pp. 99-104
DOI:
10.3323/jcorr.58.99抄録
The survey results of recent 120 leakage accidents showed that most of erosion corrosion failures of copper tubes in hot-water forced circulation system have been experienced at the downstream of joints of the return tubes. This tendency was the same as that of the research in 1996. The erosion corrosion of copper tube was observed when the concentration of dissolved oxygen in the hot-supply water was supersaturated and higher than that in supplied tap water. Therefore, it was presumed that erosion corrosion of copper tube was caused by the bubbles formed by pressure change in hot-water forced circulation system. The results of Computational fluid dynamics (CFD) simulations and the observation of the flow pattern in the model plumbing equipment showed that the locus of the micro-bubbles affect of the erosion corrosion of copper tube. According to the Young-Laplace equation, more small bubbles have high pressure in inside of the bubble, and maintain as the bubble without coalesce or collapse of bubbles. Consequently, it could be considered that erosion corrosion of copper tube occurred and propagated when the protective films formed on the tubes surfaces were continuously broken by micro-bubbles.
Corrosion Behavior of AZ31 Magnesium Alloy in Dilute Sodium Chloride Solutions
Lei Wang, Tadashi Shinohara, Bo-Ping Zhang
pp. 105-110
DOI:
10.3323/jcorr.58.105抄録
Corrosion behavior of AZ31 magnesium alloy in dilute NaCl solutions was studied by electrochemical techniques. Its surface film was chemically characterized by X-ray diffraction (XRD). A corrosion map in terms of electrode potential and chloride concentration [Cl–] was obtained by using electrochemical measurements. With the map, passivation and corrosion zones were determined. The passivation zone was found to become narrow with the increasing of [Cl–] . The values of Eocp, open-circuit potential, in nondeaerated NaCl solutions were in the passivation zone when [Cl–] <0.2 M and in the corrosion zone when [Cl–] ≥0.2 M. The reduction reactions of dissolved oxygen and hydrogen evolution worked as cathodic reactions in nondeaerated solutions. By XRD analyses, Mg(OH)2, magnesium hydroxyl carbonate, and MgO were the dominant products in the corrosion zone, whereas magnesium hydroxyl carbonate and MgO were the main components in the passivated film.
論文アクセスランキング
21 Dec. (Last 30 Days)
-
Wettability of CaS against molten iron at 1873 K
ISIJ International 早期公開
-
凝固過程における溶鋼中からAl2O3上へのMnSの晶出挙動
鉄と鋼 早期公開
-
-
In-situ Observation of Precipitation and Growth of MnS Inclusions during Solidification of a High Sulfur Steel
ISIJ International Vol.64(2024), No.14
-
-
モデル材料を用いた凝固過程における介在物生成挙動のその場観察
鉄と鋼 早期公開
-
Transition behavior of gas containing suspension from solid-like to liquid-like flows
ISIJ International 早期公開
-
-
Slag-steel reactions in the refining of Advanced High-Strength Steel
ISIJ International 早期公開
-
Chemical and Mechanical Factors on Phosphorus Dissolution Behavior from P-concentrated Slag
ISIJ International Vol.64(2024), No.14
この機能はログイン後に利用できます。
下のボタンをクリックしてください。