材料と環境 Vol. 58 (2009), No. 2
Backnumber
-
Vol. 73 (2024)
-
Vol. 72 (2023)
-
Vol. 71 (2022)
-
Vol. 70 (2021)
-
Vol. 69 (2020)
-
Vol. 68 (2019)
-
Vol. 67 (2018)
-
Vol. 66 (2017)
-
Vol. 65 (2016)
-
Vol. 64 (2015)
-
Vol. 63 (2014)
-
Vol. 62 (2013)
-
Vol. 61 (2012)
-
Vol. 60 (2011)
-
Vol. 59 (2010)
-
Vol. 58 (2009)
-
Vol. 57 (2008)
-
Vol. 56 (2007)
-
Vol. 55 (2006)
-
Vol. 54 (2005)
-
Vol. 53 (2004)
-
Vol. 52 (2003)
-
Vol. 51 (2002)
-
Vol. 50 (2001)
-
Vol. 49 (2000)
-
Vol. 48 (1999)
-
Vol. 47 (1998)
-
Vol. 46 (1997)
-
Vol. 45 (1996)
-
Vol. 44 (1995)
-
Vol. 43 (1994)
-
Vol. 42 (1993)
-
Vol. 41 (1992)
-
Vol. 40 (1991)
キーワードランキング
21 Dec. (Last 30 Days)
材料と環境 Vol. 58 (2009), No. 2
材料の環境割れの寿命予測と統一的割れ機構の可能性
西村 六郎
pp. 44-49
DOI:
10.3323/jcorr.58.44抄録
First of all, this paper describes whether or not a parameter for predicting time to failure exists on three different methods (constant load, constant strain and SSRT). In the following section, a criterion for evaluation of failure susceptibility is discussed for the constant load method. Finally, to explain the results obtained experimentally for austenitic stainless steels and pure titanium, the new mechanisms of stress corrosion cracking and hydrogen embrittlement are proposed with the unified concept and aspect
水晶振動子微小天秤(QCM)を用いた銀の硫黄蒸気による腐食挙動の解析および硫黄蒸気を用いた銀の硫化腐食試験
青木 里紗, 大坂 圭新, 面田 真孝, 酒井 潤一, 石川 雄一
pp. 56-63
DOI:
10.3323/jcorr.58.56抄録
Quartz Crystal Microbalance (QCM) technique was employed to continuously detect extremely small mass changes during corrosion of silver by sulfur vapor originated from sulfur flower as a function of temperature, RH and distance from sulfur to the silver surface. Corrosion progressed linearly with exposure time during all the tests. The corrosion rate increased as temperature rose, while no significant dependence on RH was observed. Furthermore the corrosion rate decreased markedly with increasing distance. This suggests that diffusion of sulfur vapor to the silver controls initial sulfide formation of silver.
These results have led us to propose a simple corrosion test using sulfur vapor to simulate corrosion of silver during indoor exposure of electronic equipment. The test employs the two distinct characteristics of sulfur vapor test using sulfur flower. Firstly the vapor pressure of sulfur by sulfur flower varies widely with temperature resulting a wide range of sulfur concentration. Secondly the corrosion rate of silver in sulfur vapor can be controlled by varying the distance between the sulfur flower and the silver surface.
Since the corrosion by sulfur vapor follows the linear kinetics similar to those found in practice as well as to provide identical major corrosion chemistry and morphology of the corrosion product, silver sulfide as in practice, we propose it to provide a reasonably reproducible, more flexible test which is much easier to handle in the laboratory than flowing multi-component gas mixtures containing hydrogen sulfide.
溶射皮膜上に塗装した重防食皮膜の耐食性
塗谷 紘宣, 島 貢, 石川 量大, 鈴木 紹夫, 北村 義治
pp. 64-70
DOI:
10.3323/jcorr.58.64抄録
The corrosion resistance of the composite coatings of thermal sprayed Zn, Zn-Al alloys and Al, with a simplified painting of the polyurethane resin, exposed to the atmosphere for 12 years in Sapporo and Tokyo was evaluated by the electric insulation test, the SEM observation and the EPMA. In spite of losing the electric insulation already, the simplified painting showed an excellent resistivity comparing to a conventional multi-layer painting. The diffusion of the iron through the sprayed Zn was larger than that through the sprayed Al, while the amounts of chloride and sulfur penetrating through the painting on the sprayed Al was larger than those on the sprayed Zn. This suggests that the thermal sprayed Zn layer has a tendency of the cation selective permeability. The protection at the scratched portion on the composite film seemed to be obtained by the cathodic protection in Zn, and the plug effect with the oxide in Al. Corrosivity of the atmosphere caused by chloride and sulfur was larger at Sapporo than at Tokyo. The fact suggests that the influence of the airborne salinity and the pollution substances is severe at the coast of Japan Sea, especially in a long period of the snow falling season.
論文アクセスランキング
21 Dec. (Last 30 Days)
-
Wettability of CaS against molten iron at 1873 K
ISIJ International 早期公開
-
凝固過程における溶鋼中からAl2O3上へのMnSの晶出挙動
鉄と鋼 早期公開
-
-
In-situ Observation of Precipitation and Growth of MnS Inclusions during Solidification of a High Sulfur Steel
ISIJ International Vol.64(2024), No.14
-
-
モデル材料を用いた凝固過程における介在物生成挙動のその場観察
鉄と鋼 早期公開
-
Transition behavior of gas containing suspension from solid-like to liquid-like flows
ISIJ International 早期公開
-
-
Slag-steel reactions in the refining of Advanced High-Strength Steel
ISIJ International 早期公開
-
Chemical and Mechanical Factors on Phosphorus Dissolution Behavior from P-concentrated Slag
ISIJ International Vol.64(2024), No.14
この機能はログイン後に利用できます。
下のボタンをクリックしてください。