論文検索サイト

日本エネルギー学会誌 Vol. 77 (1998), No. 6

ISIJ International
belloff
オンライン版ISSN: 1882-6121
冊子版ISSN: 0916-8753
発行機関: The Japan Institute of Energy

Backnumber

  1. Vol. 103 (2024)

  2. Vol. 102 (2023)

  3. Vol. 101 (2022)

  4. Vol. 100 (2021)

  5. Vol. 99 (2020)

  6. Vol. 98 (2019)

  7. Vol. 97 (2018)

  8. Vol. 96 (2017)

  9. Vol. 95 (2016)

  10. Vol. 94 (2015)

  11. Vol. 93 (2014)

  12. Vol. 92 (2013)

  13. Vol. 91 (2012)

  14. Vol. 90 (2011)

  15. Vol. 89 (2010)

  16. Vol. 88 (2009)

  17. Vol. 87 (2008)

  18. Vol. 86 (2007)

  19. Vol. 85 (2006)

  20. Vol. 84 (2005)

  21. Vol. 83 (2004)

  22. Vol. 82 (2003)

  23. Vol. 81 (2002)

  24. Vol. 80 (2001)

  25. Vol. 79 (2000)

  26. Vol. 78 (1999)

  27. Vol. 77 (1998)

  28. Vol. 76 (1997)

  29. Vol. 75 (1996)

  30. Vol. 74 (1995)

  31. Vol. 73 (1994)

  32. Vol. 72 (1993)

  33. Vol. 71 (1992)

日本エネルギー学会誌 Vol. 77 (1998), No. 6

Surface Properties of Coals Upgraded by Hydrothermal Treatment

Xiao-Feng XIE, Akira OHKI, Koichiro MORIMATSU, Tsunenori NAKAJIMA, Hirokazu ODA, Shigeru MAEDA

pp. 478-484

抄録

The properties of coal when the coal was hydrothermally treated at 150-350°C were examined with particular emphasis on the surface properties. The analysis of coal properties includes hygroscopicity, the content of functional groups measured by chemical analysis and FT-IR, elemental analysis, specific surface area, maceral composition, and vitrinite reflectance. Two Australian low rank coals, Loy Yang coal and Yallourn coal, were tested; while a subbituminous coal and a high rank coal were subjected to the same treatment for comparison. When the low rank coals were hydrothermally treated, the hygroscopicity of coal remarkably decreased, becoming comparable to that for high rank coals after the 350°C treatment. The content of carboxyl group greatly decreased as heat treatment temperature (HTT) was raised; whereas decrease in the content of phenolic hydroxyl group was rather small. After the hydrothermal treatment, exinite maceral in the coal almost disappeared and the absorbance for aliphatic carbon in FT-IR spectrum was somewhat raised. From these results, the change in the coal properties during the hydrothermal treatment is discussed.

ブックマーク

SNSによる共有

論文タイトル

ハニカム触媒を用いた触媒燃焼の触媒内部温度の計測と数値シミュレーション

近野 淳子, 竹内 正雄

pp. 485-491

抄録

Catalytic combustion of propane/air mixture in a honeycomb monolith catalyst was investigated. Both experiment and numerical simulation were made at 573K inlet temperature, 0.48 to 1.74 m/s inlet velocity, and 0.15 to 0.30 equivalence ratio. In the experiment, gas temperatures were measured with thin thermocouples, and substrate temperatures with an optical fiber thermometer. In the numerical simulation, a two-dimensional, steady state model was developed to calculate the velocity, temperature, and propane concentration in the catalyst. In the model, chemical reaction on the catalyst surface was assumed to be one-step oxidation, with Arrhenius type reaction rates; reaction in the gas phase was neglected. Calculated temperature profiles agree qualitatively with those experimentally obtained.

ブックマーク

SNSによる共有

論文タイトル

ハニカム触媒を用いた触媒燃焼の触媒内部温度の計測と数値シミュレーション

改質低石炭化度炭を用いたCWMの添加剤に関する研究

佐伯 隆, 立川 敬史, 薄井 洋基

pp. 492-502

抄録

Using an upgraded low rank coal would be effective to decrease the preparation cost of a coal water mixture (CWM). Some upgrading processes for low rank coals have been developed in recent years. On the other hand, the surface characteristics of an upgraded coal would be more hydrohobic rather than a normal bituminous coal. Therefore, the selection of suitable additives for both fluidity and stability of CWMs with upgraded coals is important. In this study, Indonesian coal (Banjarsari -Tanjung Enim) was used to prepare a CWM and twelve surfactants and four stabilizers were examined. From the experimental results, a CWM with the addition of both condensation product of formalin and naphthalen sulfonic acid (NSF-Na+) and bio-polysaccharide (S-194) showed good fluidity and stability. The coal concentration of the CWM was 60.5 % at the apparenet viscoity of 1 Pa · s. The information obtained in this study for various kinds of additives should be valuable for the preparation of CWMs.

ブックマーク

SNSによる共有

論文タイトル

改質低石炭化度炭を用いたCWMの添加剤に関する研究

この機能はログイン後に利用できます。
下のボタンをクリックしてください。

詳細検索

論文タイトル

著者

抄録

ジャーナル名

出版日を西暦で入力してください(4桁の数字)。

検索したいキーワードを入力して下さい