Kou kouzou rombunshuu
New Arrival Alert : OFF

You can use this feature after you logged into the site.
Please click the button below.

Log in / Sign up
ONLINE ISSN: 1884-0329
PRINT ISSN: 1880-9928

Kou kouzou rombunshuu Vol. 18 (2011), No. 70

  • Experimental study on impact performance of steel tube reinforced by small steel tubes

    pp. 70_1-70_11

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.11273/jssc.18.70_1

    The series of tests had been done in order to make resistant ability of steel tube member better against impact action as like a rock fall. Outside members were steel tubes in which were arranged by some small steel tubes and fulfilled by mortar around those tubes. Static loading tests and impact tests by the free fall of a heavy weight were achieved. Characteristics of those members had been investigated by results of tests and theoretical calculations using section sprit method. Finally, the equation to estimate the energy absorption of those steel tubes under impact concretely had been proposed.
  • A Basic Study on Earthquake Resistant Performance and Dynamic Behaviors of Steel Frame Structures with Self Strain Stress

    pp. 70_13-70_26

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.11273/jssc.18.70_13

    This paper investigates both the earthquake resistant performance and dynamic behaviors of steel frame structures with self strain stresses due to relative settlement of the structures or thermal stress within the structures. And, this paper concludes as follows: (1) the horizontal stiffness of steel frame structures tend to reduce as the self strain stress increases. And (2) this reduction contributes to increase dynamic response of the steel frame structures subjected to severe earthquake. Therefore (3) the increases of the self strain stress effect on the earthquake resistant performance of the steel frame structures.
  • Performance verification tests on rationalized joint of precast steel composite deck for replacement of deteriorated highway bridge slab

    pp. 70_27-70_38

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.11273/jssc.18.70_27

    In Japan, as so many highway bridges constructed in the last four decades became superannuated, maintenance of those bridges has become the most serious problem to extend the service lives with appropriate rehabilitation works. For the slabs, replacement of severely deteriorated slabs is a recent trend to minimum the LCC. The authors developed a rationalized joint for precast steel concrete composite decks that could shorten the construction period by reducing the joint width accompanying with decrease of concrete volume and placing re-bars. In this paper, through verification tests for the joints, characteristics of concrete cracks, stress transmission of re-bars and applicability for actual bridges, were confirmed.
  • EXTENDING FATIGUE LIFE OF GUSSETS WELDED TO PLATE EDGE BY ICR TREATMENT

    pp. 70_39-70_47

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.11273/jssc.18.70_39

    Fatigue tests of plates with gussets welded to the plate edges were fatigue tested under plate bending type of loading. When fatigue cracks initiated and propagated from the gusset ends, Impact Crack Closure Retrofit treatment, ICR treatments, were applied to the cracks in order to stop or to reduce further fatigue crack propagation. The ICR treatment is the technique to produce plastic deformation near the fatigue cracks to close opening of the crack, and thus reduce stress intensity factor. Fatigue test results showed significant improvement of remaining fatigue life after ICR treatment.
  • Experimental Study on Concrete Filled Elliptical Steel Tubular Stub Columns under Compression

    pp. 70_49-70_54

    Bookmark

    You can use this feature after you logged into the site.
    Please click the button below.

    Log in / Sign Up

    DOI:10.11273/jssc.18.70_49

    Concrete filled elliptical steel tubular, abbreviated in CFEST, structure is similar to a concrete filled tubular, so-called CFT structure and a new type of structural member consists of elliptical steel tube and in-filled concrete. Purpose of this study is to investigate centric loading characteristics of CFEST experimentally. Influence of diameter-to-thickness ratio, 2b/t(2a/t), on axially loading capacities of CFEST is mainly discussed. Furthermore, biaxial stress of the elliptical steel tube induced into core concrete is also mentioned. As a result, it can be found that axially loading capacities are affected by the ratio 2b/t(2a/t).

Article Access Ranking

17 Oct. (Last 30 Days)

  1. Perspective toward Long-term Global Goal for Carbon Dioxide Mitigation in Steel Industry Tetsu-to-Hagané Vol.105(2019), No.6
  2. Research and Application of Model and Control Strategies for Hot Rolled Strip Cooling Process Based on Ultra-Fast Cooling System ISIJ International Advance Publication
  3. Modeling of Surface Crack Defects Developed on Shear Edge in High-strength Automotive Steel Sheets ISIJ International Advance Publication
  4. Online Prediction of Hot Metal Temperature Using Transient Model and Moving Horizon Estimation ISIJ International Vol.59(2019), No.9
  5. Thermal Decomposition Reaction Kinetics of Hematite Ore ISIJ International Advance Publication
  6. Influences of Na2O, K2O and Li2O Additions on Electrical Conductivity of CaO–SiO2–(Al2O3) Melts ISIJ International Advance Publication
  7. Influence of Selective Surface Oxidation of Si and Mn on Fe–Zn Alloying Reaction on Hot-rolled Steel Sheets ISIJ International Vol.59(2019), No.9
  8. Observation of Chemical State for Interstitial Solid Solution of Carbon in Low-carbon Steel by Soft X-ray Absorption Spectroscopy ISIJ International Advance Publication
  9. Causes of Particle Trajectory Fluctuation on the Rotating Chute in Circumferential Direction at Bell-less Top with Parallel Type Hoppers ISIJ International Vol.59(2019), No.9
  10. Effects of Alloy Elements on Carbon Partitioning in Early Stages of Proeutectoid Ferrite Transformation in Low Carbon Mn–Si Steels ISIJ International Advance Publication

Search Phrase Ranking

17 Oct. (Last 30 Days)

  1. blast furnace
  2. blast furnace productivity
  3. blast furnace permeability
  4. steel
  5. hole expanding test
  6. gene
  7. heating furnace temperature control before rolling
  8. hole expanding
  9. furnace dent
  10. hearth roll