論文検索サイト

鋼構造論文集 Vol. 7 (2000), No. 25

ISIJ International
belloff
オンライン版ISSN: 1884-0329
冊子版ISSN: 1880-9928
発行機関: Japanese Society of Steel Construction

Backnumber

  1. Vol. 31 (2024)

  2. Vol. 30 (2023)

  3. Vol. 29 (2022)

  4. Vol. 28 (2021)

  5. Vol. 27 (2020)

  6. Vol. 26 (2019)

  7. Vol. 25 (2018)

  8. Vol. 24 (2017)

  9. Vol. 23 (2016)

  10. Vol. 22 (2015)

  11. Vol. 21 (2014)

  12. Vol. 20 (2013)

  13. Vol. 19 (2012)

  14. Vol. 18 (2011)

  15. Vol. 17 (2010)

  16. Vol. 16 (2009)

  17. Vol. 15 (2008)

  18. Vol. 14 (2007)

  19. Vol. 13 (2006)

  20. Vol. 12 (2005)

  21. Vol. 11 (2004)

  22. Vol. 10 (2003)

  23. Vol. 9 (2002)

  24. Vol. 8 (2001)

  25. Vol. 7 (2000)

  26. Vol. 6 (1999)

  27. Vol. 5 (1998)

  28. Vol. 4 (1997)

  29. Vol. 3 (1996)

  30. Vol. 2 (1995)

  31. Vol. 1 (1994)

鋼構造論文集 Vol. 7 (2000), No. 25

東京湾アクアラインシールドトンネルの地中接合

中西 保正, 石井 順, 舟崎 恒義, 田中 大三

pp. 1-8

抄録

For TOKYO WAN AQUA-LINE (Traps -Tokyo Bay Highway) the slurry shield method was employed. Because of the long length of tunnel the shield machines from both side were joined under the ground. In this process, the ground freezing method was used as an assistant method and slurry around shield machine was frozen at -30°C. Though machines were also cooled, it was difficult to employ pre- and/or post-heat for prevention from cold cracking. In this study, the welding procedure for water proof and reinforcement welding without pre- and/or post-heat to obtain enough joint strength was examined by experiments. The propriety of welding design was also confirmed in mock-up test. The actual underground connection was finished and TOKYO WAN AQUA-LINE is now under service.

ブックマーク

SNSによる共有

論文タイトル

東京湾アクアラインシールドトンネルの地中接合

非線形解析による鋼製連続立体ラーメン橋の耐震性評価

坪野 寿美夫, 三浦 正幸, 笠坊 英彰, 高橋 巌, 島村 和夫

pp. 9-21

抄録

In this paper, response of the three-dimensional multi-span rigid frame bridges against for the Hyogo-ken Nanbu earthquakes, a TYPE ll seismic acceleration, will be described. The bridges including seven steel piers were fully modeled by finite element model so that the interaction of the movement of each piers and elastic plastic response are able to take into account. The result shows that the relative displacement of the border of two sections is small enough compare to “Se”, overlapped length of a girder at a support and suspended joint. It was confirmed that the bridges will not be catastrophically damaged against for the TYPE ll seismic.

ブックマーク

SNSによる共有

論文タイトル

非線形解析による鋼製連続立体ラーメン橋の耐震性評価

鉛直スチフナ形式柱梁接合部における柱コーナー溶接部の力学性状

増田 浩志, 伊藤 昭栄, 藤井 俊二, 田中 淳夫

pp. 23-30

抄録

At WF beam to RHS column connections diaphragms are commonly used. In this paper statical characteristics of a new type connecting method without diaphragms were experimentally investigated. In this method the side of flanges of the beam ends were welded to vertical stiffners, and the ends of the stiffners were welded to the corners of RHS columns. It is generally recomended to avoid welding at the corners of cold formed RHS member. In this experimented study the influence of welding at those parts upon the statical characteristics of the welded connection is investigated. By means of two types monotonic tension tests and cyclic loading test it becomes clear that the welding at the corners of columns has no bad influence upon the statical characteristics of welded connections.

ブックマーク

SNSによる共有

論文タイトル

鉛直スチフナ形式柱梁接合部における柱コーナー溶接部の力学性状

兵庫県南部地震によるニールセン・ローゼ橋のハンガーの弛み・抜けの原因に関する研究

迫田 治行, 頭井 洋, 加賀山 泰一, 上平 悟, 北田 俊行, 中井 博

pp. 31-42

抄録

The Hyogo-ken Nanbu Earthquake, occurred on January 17, 1995, caused serious damage to the bridge structures. Loosening was observed in a few hanger cables of two Nielsen-Lohse bridges after the earthquake. In this paper, the causes of loosening and slackness of hanger cables during this inland earthquake are investigated through the response spectrum analysis, static elasto plastic finite displacement analysis by using the incremental seismic load and dynamic response analysis by using the actually recorded earthquake wave, of one of the two Nielsen-Lohse bridges.

ブックマーク

SNSによる共有

論文タイトル

兵庫県南部地震によるニールセン・ローゼ橋のハンガーの弛み・抜けの原因に関する研究

中低層鋼構造骨組の耐震性能

前田 憲太郎, 増田 浩志, 秋田 智, 田中 淳夫

pp. 43-52

抄録

ABSTRACT This paper is a study of earthquake-resistant ability of 75 existing low and middle rise steel buildings. Outline of the investigated structures was reported in part.1. The main items of the investigation about earthquake-resistant ability are the story drift angle at the base shear coefficient"Co"=0.2, story stiffness ratio and horizontal load-carrying capacity. The story drift angle of almost all those buildings are smaller than 1/200. The story stiffness ratio of all buildings are larger than 0.6. The horizontal load-carrying capacity Qu/Qun are larger than 1.0 in 80% buildings. Consequently, almost surveyed buildings earthquake-resistant ability satisfied the demand of the conditions of route-3 defined at the Building Standard Low.

ブックマーク

SNSによる共有

論文タイトル

中低層鋼構造骨組の耐震性能

熱処理を施したBCR材の力学的性状に関する実験的研究

松本 勇一, 小松 博, 福島 暁男

pp. 53-62

抄録

This research aims at clarifying the mechanical-property distribution in cold roll-formed steel square tubes. It is found that both corners and flat portion are significantly hardened and consequently that increases in strength, and decrease both in elongation and impact energy. However, these deficiencies are recovered by temperature annealing and normalizing. In test scope, mechanical-properties make recovery with temperature annealing. However, steel's softening was ahead of recovery on the heat treatment of normalizing.

ブックマーク

SNSによる共有

論文タイトル

熱処理を施したBCR材の力学的性状に関する実験的研究

溶接組立箱形断面柱に接合される溶接組立H形断面梁の破壊性状に関する実験的研究

東清 三郎, 鈴木 孝彦, 森田 耕次

pp. 63-77

抄録

Full-scale fracture tests were carried out to investigate the influence of the types of scallops and toughness on fracture behavior of built-up H-shaped beams. Test results show that (1) although the different modes of fracture were observed between specimens which had scallops with boxing welding and without one, there was no remark able difference on the deformation capacity between them; (2) the difference of the defor mation capacity between specimens using high toughness hot-rolled plates and specimens using low toughness one appeared clearly.

ブックマーク

SNSによる共有

論文タイトル

溶接組立箱形断面柱に接合される溶接組立H形断面梁の破壊性状に関する実験的研究

路面上の緩やかな段差によって誘起される橋梁交通振動に対する解析的考察

米田 昌弘, 徳永 法夫

pp. 79-87

抄録

Dynamic response analyses using 4-degree-of-freedom vehicle model were performed to investigate the effects of the long wavelength components on the traffic vibrations of highway bridges. The numerical results demonstrated that vibration caused by heavy running vehicles would be very dependent on the longitudinal profile of the long wavelength component which varied according to the vehicle speed.

ブックマーク

SNSによる共有

論文タイトル

路面上の緩やかな段差によって誘起される橋梁交通振動に対する解析的考察

増厚補強箱形断面柱―H形断面梁立体部分骨組架構の構造性能

藤田 謙一, 森田 耕次, 横井 圭司, 古沢 恵三, 濱野 公男, 松原 洋一, 古海 賢二

pp. 89-103

抄録

The structural performance of H-beam-and-RHS-column space subassemblages subjected to the cyclic reversal loading under high compressive force on the column are presented. The column thickness at beam-to-column connection area is increased by the induction heating process. The structural performance and failure mode of the specimens were investigated by the cyclic reversal loading test . The finite element and in-plane numerical analyses are carried out to estimate the elastic-plastic behavior of the specimens. The local strength of beam-to-column connection subjected to bi-axial bending moment is evaluated by the yield line theory.

ブックマーク

SNSによる共有

論文タイトル

増厚補強箱形断面柱―H形断面梁立体部分骨組架構の構造性能

この機能はログイン後に利用できます。
下のボタンをクリックしてください。

詳細検索

論文タイトル

著者

抄録

ジャーナル名

出版日を西暦で入力してください(4桁の数字)。

検索したいキーワードを入力して下さい