logo
言語
ブックマーク
ログアウト

ジャーナル

論文検索サイト

アカウント

© 2022 Steel Science Portal

ヘルプ

詳細検索

論文検索サイト

site
site
site
site

鋼構造論文集 Vol. 3 (1996), No. 10

ISIJ International
belloff
オンライン版ISSN: 1884-0329
冊子版ISSN: 1880-9928
発行機関: Japanese Society of Steel Construction

Backnumber

  1. Vol. 31 (2024)

    1. No.123
    2. No.122
    3. No.121

  2. Vol. 30 (2023)

    1. No.120
    2. No.119
    3. No.118
    4. No.117

  3. Vol. 29 (2022)

    1. No.116
    2. No.115
    3. No.114
    4. No.113

  4. Vol. 28 (2021)

    1. No.112
    2. No.111
    3. No.110
    4. No.109

  5. Vol. 27 (2020)

    1. No.108
    2. No.107
    3. No.106
    4. No.105

  6. Vol. 26 (2019)

    1. No.104
    2. No.103
    3. No.102
    4. No.101

  7. Vol. 25 (2018)

    1. No.100
    2. No.99
    3. No.98
    4. No.97

  8. Vol. 24 (2017)

    1. No.96
    2. No.95
    3. No.94
    4. No.93

  9. Vol. 23 (2016)

    1. No.92
    2. No.91
    3. No.90
    4. No.89

  10. Vol. 22 (2015)

    1. No.88
    2. No.87
    3. No.86
    4. No.85

  11. Vol. 21 (2014)

    1. No.84
    2. No.83
    3. No.82
    4. No.81

  12. Vol. 20 (2013)

    1. No.80
    2. No.79
    3. No.78
    4. No.77

  13. Vol. 19 (2012)

    1. No.76
    2. No.75
    3. No.74
    4. No.73

  14. Vol. 18 (2011)

    1. No.72
    2. No.71
    3. No.70
    4. No.69

  15. Vol. 17 (2010)

    1. No.68
    2. No.67
    3. No.66
    4. No.65

  16. Vol. 16 (2009)

    1. No.64
    2. No.63
    3. No.62
    4. No.61

  17. Vol. 15 (2008)

    1. No.60
    2. No.59
    3. No.58
    4. No.57

  18. Vol. 14 (2007)

    1. No.56
    2. No.55
    3. No.54
    4. No.53

  19. Vol. 13 (2006)

    1. No.52
    2. No.51
    3. No.50
    4. No.49

  20. Vol. 12 (2005)

    1. No.48
    2. No.47
    3. No.46
    4. No.45

  21. Vol. 11 (2004)

    1. No.44
    2. No.43
    3. No.42
    4. No.41

  22. Vol. 10 (2003)

    1. No.40
    2. No.39
    3. No.38
    4. No.37

  23. Vol. 9 (2002)

    1. No.36
    2. No.35
    3. No.34
    4. No.33

  24. Vol. 8 (2001)

    1. No.32
    2. No.31
    3. No.30
    4. No.29

  25. Vol. 7 (2000)

    1. No.28
    2. No.27
    3. No.26
    4. No.25

  26. Vol. 6 (1999)

    1. No.24
    2. No.23
    3. No.22
    4. No.21

  27. Vol. 5 (1998)

    1. No.20
    2. No.19
    3. No.18
    4. No.17

  28. Vol. 4 (1997)

    1. No.16
    2. No.15
    3. No.14
    4. No.13

  29. Vol. 3 (1996)

    1. No.12
    2. No.11
    3. No.10
    4. No.9

  30. Vol. 2 (1995)

    1. No.8
    2. No.7
    3. No.6
    4. No.5

  31. Vol. 1 (1994)

    1. No.4
    2. No.3
    3. No.2
    4. No.1

キーワードランキング

21 Nov. (Last 30 Days)

鋼構造論文集 Vol. 3 (1996), No. 10

阪神・淡路大震災で破断した柱梁仕口部近傍と破面の調査

杉本 浩一, 高橋 泰彦

pp. 1-6

DOI:

10.11273/jssc1994.3.10_1

抄録

A 5-story building was demolished owing to the large number of fractures suffered in its beam-column-connections during the Hanshin-Awaji Earthquake. Investigation results of this seismic damage will provide very important teaching material for evaluating existing connection forms. Seismically damaged beam flanges are examined, and analyzed to determine their fracture modes and their tensile, absorbed energy and hardness properties. The heat effects on steel adjacent to repair welding are also examined. This paper describes observations of the initial crack growth leading to brittle failure. It also investigates the material properties of the base metal and compares them with those of the degenerated area and those weld heat-affected zones.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

阪神・淡路大震災で破断した柱梁仕口部近傍と破面の調査

twitter
facebook
mendeley

Bibtex

Ris

超高強度コンクリート充填鋼管柱を用いた生田神社拝殿の復旧設計と施工

岡本 達雄, 福山 国夫, 東端 泰夫, 土田 伸治, 半田 健二, 益尾 潔

pp. 7-19

DOI:

10.11273/jssc1994.3.10_7

抄録

The 1995 Hyogoken-Nanbu Earthquake attacked Kobe on January 17, 1995 and brought us the huge destruction. At the IKUTA shrine, a lot of buildings were damaged and the Hall of Worship fell down completely. In the ruins, the superior priest of the shrine requested us to restore the buildings as soon as possible to encourage citizens of Kobe. Then reconstruction of the shrine started on January 22, 1995. The progressive technology to give the buildings sufficient seismic resistant capability is intended. For the columns of the new Hall of Worship, CFT(Concrete Filled steel Tube) is used, and the concrete which compressive strength is 160 NJmm2, is filled into the tube. The reconstruction procedure of the new Hall will be reported herein.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

超高強度コンクリート充填鋼管柱を用いた生田神社拝殿の復旧設計と施工

twitter
facebook
mendeley

Bibtex

Ris

許容応力度設計された中低層鋼構造骨組の強度特性に関する一考察

小川 厚治, 黒羽 啓明, 吉田 朋弘

pp. 21-28

DOI:

10.11273/jssc1994.3.10_21

抄録

The allowable stress criteria is more frequently governing the design than the ultimate limit state criteria in most of steel frames. In this paper, steel frames with rectangular hollow section columns and wide flange beams are designed based on the following rules. Beams are proportioned so that maximum stresses just reach allowable stresses. Columns are proportioned to fulfill the story drift limitation and to keep maximum stresses within allowable stresses. The ultimate strength of these frames is then discussed. The results obtained from this study are summarized as follows: (1) Members in upper stories are relatively stronger than those in lower stories. (2) Frames tend to be of weak beam type structures. (3) When a sway mechanism fomns in a story, the collapse load corresponds to a DS -value of 0.32 or greater,

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

許容応力度設計された中低層鋼構造骨組の強度特性に関する一考察

twitter
facebook
mendeley

Bibtex

Ris

孔あき鋼管部材の座屈強度に関する実験的研究

西村 宣男, 村上 茂之, 竹内 修治, 遊田 昌樹

pp. 29-38

DOI:

10.11273/jssc1994.3.10_29

抄録

The cylindrical tubular steel members are widely used as the column members in the steel structures. There are lots of studies on the buckling strength of steel tubular column and the design formulas are proposed. But there are few studies onthe perforated members or the tubular column with variable thickness. It is possible to occur the deterioration of strength owing to the decreasing of cross-section, the stress concentration around hole and the interactive behavior of both. In this report, the buckling strength of the perforated cylindrical tubular column is tested and the influence of the hole on the deterioration of buckling strength is studied.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

孔あき鋼管部材の座屈強度に関する実験的研究

twitter
facebook
mendeley

Bibtex

Ris

コンクリート充填鋼管長柱の累加耐力評価に用いるコンクリート柱の耐力

津田 恵吾, 松井 千秋

pp. 39-48

DOI:

10.11273/jssc1994.3.10_39

抄録

In AIJ (Architectural Institute of Japan) design formula for slender composite columns, modified method of the superposed strength of a column section is adopted by considering the effect of additional bending moment (Pδ moment) . In this paper, with respect to the ultimate strength of concrete filled steel tubular columns, end moment (cMu)-axial force(cNu) interaction relations are calculated by assuming a sine curve deflected shape of a concrete beam-column. The value of concrete compressive strength ranges from 240kg/cm2 to 960kg/cm2. On the basis of the analytical results, the interaction relations are proposed as an algebraic equation. Moreover, example for calculating the end moment-axial force relations is demonstrated.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

コンクリート充填鋼管長柱の累加耐力評価に用いるコンクリート柱の耐力

twitter
facebook
mendeley

Bibtex

Ris

スカラップを有する実大鉄骨梁の単調および繰返し加力下における力学的特性と破壊性状に関する研究

立山 英二, 湯田 誠, 田中 利幸

pp. 49-60

DOI:

10.11273/jssc1994.3.10_49

抄録

To investgate the failure charactristics of beam-to-column welded joints and the plastic deformation capacity of steel beam caused by scallops, a monotonic loading and cyclic loading one were carried out for full scale models which were cantilever beams. The present paper describes an outline of these tests and discussions on the ovserved test results. While the previous tests for reduced steel beams showed that the type of the scallop had an effect on the deformation capacity of the steel beam [6]-[11], the present test for full scale beams did not disclose that the plastic deformability would be governed by the type of scallop.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

スカラップを有する実大鉄骨梁の単調および繰返し加力下における力学的特性と破壊性状に関する研究

twitter
facebook
mendeley

Bibtex

Ris

斜張橋に関するデータベースの作成と基本設計用エキスパートシステムの構築

杉山 俊幸　, 長井 正嗣, 藤野 陽三

pp. 61-71

DOI:

10.11273/jssc1994.3.10_61

抄録

In order to acquire the knowledge required in an expert system for preliminary design of cable-stayed bridge, a database regarding to 137 cable-stayed bridges which are now under service and erection has been constructed. Then, an attempt has been made to develop its expert system, into which the information and knowledge obtained from the constructed database and the existing resear ches related to the cable-stayed bridges are incorporated. If only total length and width of the bridge are input into this system, then the appropriate types of cable system, pylon and main girder are suggested. And the rough total steel weight, axial force of pylon, non-linear bending moment of main girder, critical wind speed for flutter, etc. are indicated. A schematic perspective of the suggested cable- stayed bridge can be also shown on a display if the user requests it.

mendeley

ブックマーク

詳細

PDFダウンロード

SNSによる共有

論文タイトル

斜張橋に関するデータベースの作成と基本設計用エキスパートシステムの構築

twitter
facebook
mendeley

Bibtex

Ris

論文アクセスランキング

21 Nov. (Last 30 Days)

この機能はログイン後に利用できます。
下のボタンをクリックしてください。

詳細検索

論文タイトル

著者

抄録

ジャーナル名

年

出版日を西暦で入力してください（4桁の数字）。

検索したいキーワードを入力して下さい